R32 Skyline GTR – NRG Quick Release & Short Hub Install




Hey guys, I finally got my NRG Quick Release, Steering Wheel, and Short Hub installed into my R32 Skyline GTR! I wanted to wait until after my HICAS Delete was finished because this short hub is not compatible with HICAS as the sensor in the steering column needs to be removed. If you’re interested in getting the same hub, quick release, lock, or steering wheel as me, please use my Amazon links below. It helps to support my website and projects! Take care and enjoy!

NRG Steering Wheel – http://amzn.to/1N8GSZu
NRG Quick Release – http://amzn.to/1N8GURf
NRG Short Hub – http://amzn.to/1FoDJhX
NRG Quick Lock – http://amzn.to/1N8H23b

https://www.youtube.com/watch?v=nCC1BVi4f5A




NRG Short Hub | NRG Quick Release | NRG Quick Lock | NRG Steering Wheel

5 comments

  1. Joey Reply

    Do you know which hubs are compatible with Hicas?
    I’ve got a 93 R32 and am searching for one.
    Most of the results seem a bit shady, so if you have any advice, it’d be appreciated.

    • flowgoode Post authorReply

      Joey, I’m not sure which hubs would be compatible. I know there are some that exist, I just haven’t researched it enough. From what I can remember, the hubs that work with the HICAS aren’t usually for quick disconnect because it would stick out too far.

  2. Vi Reply

    Did you ever figure out why the horn didn’t work afterwards? About to do this same swap on my 92 GTR with HICAS delete and curious if there’s anything I should look out for.

Leave a Reply to Joey Cancel reply

Your email address will not be published. Required fields are marked *